All in stainless steel 18/10 AISI 304. The washing tunnels are composed of different modules, allowing for disassembly to facilitate entry and then easy assembly once in the workplace. The entire tunnel is manufactured with a double wall, including the guillotine doors, reducing noise and heat loss. The tubs are built-in with rounded edges for easy cleaning. Additional modules include pre-wash angle modules, angle drying modules, intermediate neutral modules, or neutral entry zone modules, detergent and rinse aid dispensers, etc.
The filter consists of a flat and inclined surface for solid waste drainage and a basket that collects them. Easily removable for emptying and cleaning. They allow an entry height of 450 mm for baskets of 500x500, capable of washing trays, GN containers, and other utensils. Basket movement is facilitated by lateral guides, enhancing cleaning. The basket-moving teeth are made of thick stainless steel. They are reversible, allowing for a change in entry or exit direction with simple operations. However, it's recommended to specify the direction upon ordering for factory preparation.
The basket's advancement speed is electronically regulated through a frequency converter and controlled from the control panel. Each pre-wash/wash/rinse and drying module starts and stops independently only if a basket is actually inside, improving energy consumption. The control is managed through an electronic control panel with a multifunction display, a 4-digit LED, and 4 touch buttons to program all functions, select programs, etc. With USB connection.
The recommended water feeding temperature is from a heater, between 40 to 60°C, as indicative production data is based on this. If the water enters from 15 to 40°C, production will be lower with higher energy consumption, influenced by the heat recovery module. It includes 2 baskets (multi-purpose and for dishes) and 1 cutlery container. Adjustable stainless steel legs, 200 mm. Washing/rinsing module with a length of 1150 mm, featuring a 70-liter tank, a washing system with 5 arms and 60 nozzles, a double-flow pump of 2.7 kW, and electronic temperature control.
A constant feeding pressure of 2 to 4 bar is necessary after the washing/rinsing process. It is 600 mm in length and stays at the height of the exit table. Manufactured with a double wall, operates at a low temperature of 65°C, utilizing an airflow of 1400 m3/h, extracted outside by a 550 W turbofan. The module is equipped with drainage.
